blOck Plus

What You Need: (click to shop)

blOck Plus

Getting Started

You can use blOck Plus™ to create digital barriers Bob will not cross. blOck Plus™ runs on 4 AA batteries (not included).

blOck Plus™ emits a barrier from its left side and another from its front. You may use one or both barriers depending on your preference.

As with Bob’s charging station and remote, you will need to sync blOck Plus™ before using it for the first time.

Located on the back of blOck Plus™ are three buttons:
1. Power button for the left barrier
2. Power button for the front barrier
3. SYNC button

Syncing blOck Plus™

1. Press the up arrow button. Now the power light on the front side of blOck Plus™ will turn on, stay still for 10 seconds, and then slowly blink every 3 seconds. This means blOck’s front barrier is ON and ready to sync.

2. Press the left arrow button. The power light on the left side of blOck Plus™ will turn on, stay still for 10 seconds, and then slowly blink every 3 seconds. This means blOck’s left barrier is ON and ready to sync.

3. Hold down sync button while at the same time flipping Bob’s power switch ON. Bob will chirp twice to let you know the sync was successful.

Now that Bob is synced to blOck Plus™, you may use it to section off areas of your home. You can sync multiple blOcks with Bob.

Turning Digital Barriers ON and OFF

Left Barrier:
- Press the left arrow button. The red power light on the left side of blOck Plus™ will turn on. Press again to turn off. The power light will disappear.

Front Barrier:
- Press the up arrow button. The red power light on the front side of blOck Plus™ will turn on. Press again to turn off. The power light will disappear.

blOck Plus™ will remain ON for three hours before entering standby mode. When running low on battery, the blOck’s red power lights will begin to blink rapidly. To conserve battery, turn the blOck OFF when it is not in use.